F un thank you card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Lemon Lolly Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Basic Black Cardstock
- 3-7/8" x 5-1/8" of rows of little white lines on Lemon Lolly background design from Subtles 6" x 6" Designer Series Paper, cut so the lines are vertical on the vertical rectangle
- 2-3/4" x 4-1/4" from Basic Black Cardstock
- 2-5/8" x 4-1/8" of white circles on Lemon Lolly background design from Subtles 6" x 6" Designer Series Paper
- 2-3/4" square from Basic Black Cardstock
- 2-3/4" square from Basic White Cardstock
Adhere the large piece of little white lines on Lemon Lolly background Subtles Designer Paper to the center of the large Basic Black rectangle and then to the front of the Lemon Lolly card.
Adhere the piece of white circles on Lemon Lolly background Subtles Designer Paper to the center of the smaller black rectangle.
Adhere the matted circles designer paper to the front of the card so it is about 5/8" from the left, top, and bottom edges.
Pick out the circle die that cuts out a circle that is 2-1/2" diameter from the Deckled Circles Dies. Put it on top of the Basic Black square on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
As you are ready to stamp using the Biggest Wish Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the block "thanks" word from the Biggest Wish Set on Block C. Ink it up with the Lemon Lolly Ink Pad. Stamp it slightly below center in the center of the white square.
Mount the script "hello" word from the Biggest Wish Set on Block B. Ink it up with the Tuxedo Black Memento Ink Pad. Stamp it on the white square so it is centered side to side and just overlaps the top of the "thanks" words a bit as shown.
Pick out the circle die that cuts out a circle that is 2-1/8" diameter from the Deckled Circles Dies. Put it on top of the stamped sentiments square on a platform on your Stampin' Cut & Emboss Machine so the words are centered as much as possible in the circle. You will cut off a bit of the bottom corners of the "thanks" word. Run through the machine.
Adhere the sentiment circle cut out to the center of the black circle cut out.
Adhere the matted sentiment circle cut out to the front of the card as show so the right edge of the circle is about 3/8" from the right edge of the card and the bottom of the circle is about 1-1/8" from the bottom of the card.
Cut a 12" piece of the Lemon Lolly twine from the Baker's Twine Three Color Pack.
Fold the twine in half. Tie a small bow in the center of the folded twine. Trim the ends.
Use a squished up Mini Glue Dot to adhere the twine bow to the front of the card as shown near the left bottom of the "thanks" word on the sentiment circle.
Use the mini spatula on the Take Your Pick to carefully peel up 3 large Lemon Lolly dots from a sheet of Rainbow Adhesive-Backed Dots making sure that you get the adhesive backings as well. Adhere them to the front of the card as shown so they are centered inside some of the white circles on the designer paper around the sentiment circle.